|
|
| |
|
|
| |
| MULTI-SPINDLE EQUIPMENT |
Acme
In 2005, Kaddis Manufacturing upgraded the Acme-Gridley department. Equipment remanufactured to OEM specs was put in place A Tech-Drive system was added for better control over Speeds and Feeds, which can result in a faster cycle time and savings for our customers.
Kaddis has 5 Acme-Gridley machines as follows:
 4 Six Spindle Acme Gridley
1 Six Spindle Acme Gridley – Tech-Drive
The capacity range for this equipment is:
Round Bar: 1/2” (13mm) to 1 ¼” (32mm)
Hexagon Bar: 1/2” (13mm) to 1” (25mm)
Square Bar: ½” (13mm) to 7/8” (22mm)
Davenport
Kaddis Manufacturing’s Davenport equipment undergoes a complete remanufacture every seven years by Kaddis personnel. We believe Kaddis is the only machining company that remanufactures Davenports to “Better than New” standards. The Davenport machine is stripped down to the base casting. By using unique proprietary methods and controls we ensure Three Dimensional Alignment on the revolving and stationary heads. We are able to reduce the spindle to spindle tolerance to within ten thousandths instead of thousandths of an inch. This translates into less variation from spindle to spindle or part to part. A Davenport machine remanufactured at Kaddis equals Quality Equipment, Cost Contained, and World Class Parts.
Kaddis has Davenport machines as follows:
40 Five Spindle Davenports
6 Five Spindle Davenport Chuckers
The capacity range for this equipment is:
Round Bar: 1/8” (3mm) to ¾” (20mm)
Hexagon Bar: 1/8” (3mm) to 5/8” (16mm)
Square Bar: 1/8” (3mm) to 9/16” (14mm) | | |
|
|
|
